Honda TRX 450R banner

1 - 5 of 5 Posts

·
Registered
Joined
·
120 Posts
Discussion Starter #1
Hey I wanted 2 clean my friends carb but it was so frigen dirty and rusty that I cant even take off the screws. I alredy striped one. And that was after I put a bunch of wd-40. And yes I did wait for it 2 kick in. Im wondering wtf I can do 2 get them off... Cuz his engin is not evne running cuz its so gumed up. (been sitting in the shed for more then 6 months and he did not empty it) dumb crap ah? lol Well ty
 

·
Big Bore Killer
Joined
·
2,550 Posts
i had this happen on a carb once...
i cut slits in all the screws so i could use a flat head screwdriver....
if not buy a new one.....
lesson learned
 

·
Registered
Joined
·
1,003 Posts
impact drivers work great
 

·
Registered
Joined
·
1,003 Posts
also tapping on the screws head a few times with a punch and hammer before trying it will normally help alot
 

·
Registered
Joined
·
120 Posts
Discussion Starter #5
thx every one. Ill give the impact a shot then give it a couple hard hits with a hammer.. Then if that does not work cut the slits. And yeh.. My friend lernt his lesson.. ty again
 
1 - 5 of 5 Posts
Top