[Bullvine rider!!]

Can someone tell what this wire is for please? It’s connected to the middle green connection on left side under the hood. Refer to pic. And it has a fuse of some sort on the other end, with a small red button. It was tucked away behind my headlight, not hooked up to anything. Just hanging there.
Im absolutely clueless when it comes to wiring harness on these machines.

 

[phillybuilt]

Throttle switch. I typically unplug them, cut the wire so they are about 3" long, then strip the ends and solder the wires together, throw some heat shrink over the joint to seal it. Do the same with the two wire sensor on the carb.

Sent from my SM-G973U using Tapatalk

 

[Bullvine rider!!]

Throttle switch. I typically unplug them, cut the wire so they are about 3" long, then strip the ends and solder the wires together, throw some heat shrink over the joint to seal it. Do the same with the two wire sensor on the carb.

Sent from my SM-G973U using Tapatalk

To bypass them both correct? ok I gotcha, thank you sir.

 

[CJM]

yup throttle sensor. i bypassed mine cause im running a older style 400/450r throttle with a trx90 lever for more leverage