Honda TRX 450R banner
1 - 1 of 1 Posts

· Registered
4,933 Posts
Discussion Starter · #1 ·
I took some pics of myself installing my prodesign killswitch. The 1st thing i did was followed the wires from my keyswitch to just under the hood and cut and stripped them.

once you do that connect the red wire and the black wire together

then take the green wire and connect it to one of the killswitch wires and the black and white wire to the remaning killswitch wire and your done

the black keyholder thing pulls right up off the handlebars pretty easily then you have to find a place to mount the temperture light. i mounted mine right above the radiator cap

i used electrical tape on all my wires which will work just fine, just make sure you wrap them good and tight. The best way is to soder the wires and use butt connectors though.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.