Honda TRX 450R banner
1 - 6 of 6 Posts

·
Registered
2006 trx500er (aka, Bruno) Athena 500 big bore, hot cam, and gutted exhaust
Joined
·
6 Posts
Discussion Starter · #1 · (Edited)
I’m getting a maier scooped hood and therefore removing the stock headlight. I was just wondering if you guys know of any cheap lighting options. I looked at lazr star but I just don’t want to spend $250 on lights. Some ideas and pics would be nice. Thanks in advance!
 

·
Registered
2006 trx500er (aka, Bruno) Athena 500 big bore, hot cam, and gutted exhaust
Joined
·
6 Posts
Discussion Starter · #2 ·
I know that’s a mouth full so basicly what I’m trying to say is…
 

·
Registered
2006 trx500er (aka, Bruno) Athena 500 big bore, hot cam, and gutted exhaust
Joined
·
6 Posts
Discussion Starter · #3 ·
How do I know how far to adjust this screw
152237



this screw (on the throttle cable):
152238

And this one up by the throttle
152239

do I just put them all as tight as possible? Thanks in advance
 

Attachments

·
Registered
Joined
·
488 Posts
That screw you circled in yellow is just a throttle stop so that way it don't go to far. You should never have to remove that for any reason.

To install or remove the cable it's just as simple and turning the throttle shaft with your fingers and remive the cable. You have mode this way more complicated then it needed to be.
 

·
Registered
2006 trx500er (aka, Bruno) Athena 500 big bore, hot cam, and gutted exhaust
Joined
·
6 Posts
Discussion Starter · #5 ·
That screw you circled in yellow is just a throttle stop so that way it don't go to far. You should never have to remove that for any reason.

To install or remove the cable it's just as simple and turning the throttle shaft with your fingers and remive the cable. You have mode this way more complicated then it needed to be.
How do I know if it is to lose or to tight?
 
1 - 6 of 6 Posts
Top