Honda TRX 450R banner
1 - 8 of 8 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
my kickstarted moved i guess and now it wont go into the indentation in the plastics under the seat.....anyone know how to fix this?
 

·
Registered
Joined
·
183 Posts
check and see if your plastics have shifted and make sure that all of the motor/ frame bolts and plastic/frame bolts are on tight and that everything is lined up correctly. this would be the first time that I personally have heard of this problem.
 

·
Registered
Joined
·
5,212 Posts
Originally posted by atvrider12764@Jun 7 2004, 05:15 PM
my kickstarted moved i guess and now it wont go into the indentation in the plastics under the seat.....anyone know how to fix this?
Will it not go into the right place or is it not staying there? If it isn't staying there, then you have to replace some type of bearing, just look at the parts on Service Honda to find what you need.
 

·
Registered
Joined
·
22 Posts
Discussion Starter · #4 ·
it works it just wont go into the right place.....it need to go down about an inch....its not going into the indent in the plstics
 

·
Registered
Joined
·
181 Posts
can you take it of and move it on the teeth kinda like your gearshifter?
 

·
Registered
Joined
·
453 Posts
Originally posted by blake450r@Jun 8 2004, 09:41 PM
can you take it of and move it on the teeth kinda like your gearshifter?
thats what i was thinkin, its worth a try.
 

·
Registered
Joined
·
3,362 Posts
it probably just skipped a couple of teeth when you were kicking it...they might not have gotten it tight enough from factory...just re-adjust it.
 

·
Registered
Joined
·
3,687 Posts
I know you probably thought of this, but I would take it back to the place you bought it. Act dumb and make them fix it. I always have the Honda shop do stuff for me. I know it cost allot of money. But, then it's warranted!!! :)
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top