Honda TRX 450R banner
1 - 2 of 2 Posts

·
Registered
Joined
·
531 Posts
A lot of the times if it's the starter clutch (One Way Bearing) it will sound like a metallic clunk and (almost sound like the piston hitting the valves) but it's the 1 way bearing.

Here is the parts you will need.


Part #5 (In diagram) - 28115-MEY-670
Part #4 (In diagram) - 28110-MEY-670
Part #7 (In diagram) - 28125-MEY-671
Part #8 (In diagram - 28127-MS2-612
 

Attachments

·
Registered
Joined
·
531 Posts
Thanks for the reply, yea seems like it has been replaced before by someone before me because i see gasket maker on the edges of the cover, must’ve used the eBay one. What does it sound like when it’s the reduction gear though because I want to make sure that’s good too? I’ve seen a video where the reduction gear is supposed to move as a unit, and then the starter clutch should only spin one way just want to make sure that’s the correct way to check them.
Hey sorry for the late response, anyways I would go OEM they're pricy as hell but totally worth the money. Also never use RTV gasket maker usually the gasket and 7ft pounds on each bolt is all it needs to seal.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top