Honda TRX Forums: Honda TRX 450R Forum - View Profile: Ryan94Wright

Ryan94Wright Ryan94Wright is offline

250EX Rider

  Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. yfz450admirer1
    11-16-2018 05:28 PM - permalink
    yfz450admirer1
    My quad locked up the other day, after having been briefly warmed up. I pulled the top-end and the piston and rings looked good. The cylinder had some black markings on half of it. With the cylinder off the rod would rotate through 1/2 of the cycle and then wouldn't budge. I pulled the stator side of the casing and the rod will now rotate through the entire cycle smooth as butter. I found one flattened piece of aluminum 1/4 inch by 1/3 inch and a few other smaller pieces in the bottom of the crank case on the stator side. I pulled the oil filter and it has a ton of shavings. Any ideas of why this seized and where the aluminum shavings are coming from? I pulled the stator and there do not appear to be any issues there.
    Looking at it closer it looks like one of the washers is gone that seats up against the rod in the crank.


    My quad is pretty worn out. Do you think I should just part it out? I don't think my quad running is worth more than 1500.

  About Me

  • About Ryan94Wright
    Biography
    I am not a Know it all, I just explain the best I can using my own experience.
    Location
    Tucson Arizona
  • Signature
    Build Break Rebuild Better

  Statistics

Total Posts
Albums
Visitor Messages
General Information
  • Last Activity: Yesterday 04:18 AM
  • Join Date: 09-13-2015
  • Referrals: 0

  Friends

Showing Friends 1 to 2 of 2
  • Cultcc00
    • Cultcc00 is offline
  • ghott
    • ghott is offline
    • Send a message via MSN to ghott
    • Send a message via AIM to ghott

  Mentions

10-01-2019
03:37 AM - Ryan94Wright mentioned Michael in post What to look for
Michael Yep it's a very well...
09-24-2019
02:23 AM - Ryan94Wright mentioned Auricon in post Special Wrench Tighten 400 & 450 Chain
Auricon That only works with...
02:23 AM - Ryan94Wright mentioned garyleif in post Special Wrench Tighten 400 & 450 Chain
... not the TRX450. garyleif To answer your quest...
07-25-2019
06:57 AM - Ryan94Wright mentioned randystone450r in post Jet size ?
randystone450r No they do not. Th...
07-05-2019
06:56 AM - Ryan94Wright mentioned hawk-trx in post bigbore and hi compression piston vs standard hi compression piston
hawk-trx I was just saying I...
06:52 AM - Ryan94Wright mentioned CJM in post kickstart seized, wont bump start
...d the same thing as CJM I guess I need to re...
02-21-2019
04:28 AM - Ryan94Wright mentioned Cultcc00 in post Porting
Cultcc00 I am running the s...
02-20-2019
04:51 AM - Ryan94Wright mentioned CJM in post FCR jetting 06+
CJM Ohhh my bad about t...
02-08-2019
04:08 AM - Ryan94Wright mentioned hoser in post Cam info 2.0
hoser True, springs are ...
01-15-2019
05:51 AM - Ryan94Wright mentioned Nite302 in post 2006 450er need valve advice
Nite302 As far as I know yo...
12-29-2018
06:19 PM - Logankl mentioned Ryan94Wright in post Coolant in clutch and transmission
Ryan94Wright No I didn't rebuild...
12-25-2018
07:46 AM - Ryan94Wright mentioned Logankl in post Coolant in clutch and transmission
Logankl Did you happen to d...
12-24-2018
07:06 AM - Ryan94Wright mentioned Auricon in post easiest way to 50hp
Auricon No way that a 05 w...
12-22-2018
07:55 AM - Ryan94Wright mentioned gboezio in post 04-05 TRX450R Stator Resistance Specs
gboezio So I got some new Re...
12-21-2018
07:09 AM - Ryan94Wright mentioned Thrown Stones in post 04-05 TRX450R Stator Resistance Specs
...rk tonight Thanks. Thrown Stones Thanks man. I Will g...
07:08 AM - Ryan94Wright mentioned gboezio in post 04-05 TRX450R Stator Resistance Specs
gboezio I'll check that whe...
12-18-2018
07:05 AM - Ryan94Wright mentioned alanbmx in post Hey Guys.
alanbmx haha seen that video...
12-08-2018
01:58 AM - Ryan94Wright mentioned morgan in post I need a 97mm High Compression Piston...
morgan What a small world l...
12-06-2018
06:11 AM - Ryan94Wright mentioned Thrown Stones in post I need a 97mm High Compression Piston...
...makes a ton more. Thrown Stones Yeah I tried to mes...
06:10 AM - Ryan94Wright mentioned hoser in post I need a 97mm High Compression Piston...
hoser lol Yeah I have e...

  Quotes

08-03-2019
12:17 PM - hawk-trx quoted Ryan94Wright in post FCR Accelerator Pump Question
I have a FCR Carburetor om a 2007...
07-25-2019
02:16 AM - Ryan94Wright quoted gboezio in post Won’t idle
I might have mis typed somet...
07-17-2019
07:47 AM - Sigshot quoted Ryan94Wright in post ‘05 FCR conversion assistance.
The Tan, Black Stripe wire and th...
07-06-2019
10:38 PM - Big.ron450r quoted Ryan94Wright in post Dasa/ Sparks
I'm not sure if the Muffler will ...
06-21-2019
08:31 PM - Cultcc00 quoted Ryan94Wright in post ‘05 FCR conversion assistance.
Hello folks. Looking for a little...
06-20-2019
08:14 PM - Tac quoted Ryan94Wright in post What jet size?
First thing I would suggest as CJ...
03-12-2019
10:14 PM - ItsAllAboutWins quoted Ryan94Wright in post Clicking noise coming from air intake and dies on throttle stab
Yeah I agree it sounds like the T...
03-07-2019
02:58 PM - Cultcc00 quoted Ryan94Wright in post 04 Trx 450
The toque seems low... The HP see...
03-02-2019
01:47 AM - Ryan94Wright quoted hoser in post Oil pump won't turn
Thatís one reason I donít ...
02-21-2019
12:24 PM - Cultcc00 quoted Ryan94Wright in post Porting
Cultcc00 I am running the stage...
02-08-2019
03:23 PM - Thrown Stones quoted Ryan94Wright in post Primary Gear Bolt
Check to make sure that the Bolt ...
01-27-2019
02:03 AM - Fleeela quoted Ryan94Wright in post 2014 trx450er good numbers?????
Stock horse power of a 06 and up ...
01-18-2019
07:14 AM - Thrown Stones quoted Ryan94Wright in post 05-450r help
Stock carb, never bought the FCR ...
01-13-2019
11:40 AM - Nite302 quoted Ryan94Wright in post 2006 450er need valve advice
Yeah I think those intake valves ...
12-27-2018
08:32 PM - CJM quoted Ryan94Wright in post Stripped oil filter housing.
What about taking the cover off d...
12-26-2018
08:16 PM - Auricon quoted Ryan94Wright in post easiest way to 50hp
I'm in no way trying to sound lik...
12-21-2018
07:33 AM - Thrown Stones quoted Ryan94Wright in post 04-05 TRX450R Stator Resistance Specs
gboezio I'll check that when I g...
12-06-2018
01:08 PM - Cultcc00 quoted Ryan94Wright in post 2004 FCR swap
Oops I never hit send sorry i gue...
12:54 PM - Cultcc00 quoted Ryan94Wright in post I need a 97mm High Compression Piston...
hoser lol Yeah I have enough e...
11-30-2018
05:11 PM - Cultcc00 quoted Ryan94Wright in post 2004 FCR swap
YES... After I did some research ...
 
For the best viewing experience please update your browser to Google Chrome