is there anything anyone would recommend to reapply graphics that have fallen off. mine have have fallen off my tank and would like to put the back on but they are not very sticky anymore.

all i could say is try heating them up with a hair dryer or a heat gun

Use a product called "sticker on"
that should do the trick

where can you find this product??

I used some spray on crafts glue my wife had, it lasted about 9 months

I would have kept respraying but one side ended up getting ripped so I trashed them and went with a different set

you can get spray glue at wal-mart (get some alcohol to clean everything first)

I got some 3M stuff from Napa that works good. It works good enough until i can save for a new graphics kit.

On our 400ex the graphics began peeling around the bottom of the tank. I used a very thin coat of epoxy and it has held ever since.

super glue will permittly fix ur problem